I am trying to get ADTpro to download onto my Apple II Europlus. Everything appears to work fine and the code begins to download until it stops around 95% through the process with an error 'RELOCATION/ CONFIGURATION ERRO'.
I made some enquiries and realised I need 64k to get ADTpro to work and so put some brand new memory chips into a 16k card I had and put it into the machine. The machine successfully ran the 48k test described elsewhere on this forum, but I am wondering if I have a problem on this card meaning I dont have the full 64k available. With the RAM card on board, the ADTpro download fails at roughly the same point. I dont have any diagnostic software disks to look at for help.
Thanks
Well it sounds like it is the card or a chip on the card. I would Turn off the power. Unplug the machine and pull the card. I would reseat all of the chips. I might be even inclined to slightly remove them after I reseated them. That is slightly pry them up to reseat them a second time and to clean the insertion edge of the card. Then try it again. I am sure some one should come up with some software that will help you further.
Take Care
Hello Atomtan,
You can use the diagnostic dealer disc available at Mac GUI.
In the "interface card" menu, there is a dedicated entry for the language card. If one (or more) chip is bad, it will tell you which one.