Drivers

This is a VERY hard to find driver that enables the cache on this CPU upgrade. The card works without it but is barely faster than the original 166mhz CPU.

This is the firmware for the replica 1. Contained are 3 .asm files which can be viewed with a text editor. This is the firmware code used for the video, ps/2 decoder and serial I/O board. This software is for personal use only and maynot be used for commercial use without permission.

Please read the documentation to ensure smooth installation.

This software supports Sante MacCon Ethernet Cards and Asante EN/SC Ethernet Adaptors.

Be sure to read all the documentation to ensure you are aware of all requirements.

WHAT'S NEW:

New Features in version 5.02:

• Made the Application Menu response easier to get to by moving it to the top level of the Response menu.
• Added a feature called Instant Menu, which pops up the application's menu bar at the current cursor position.

This installer will install software to use your BrainStorm Accelerator. The system software included on this disk is only for use in updating, do not try and copy it to your hard disk for general use or your Macintosh my fail to operate. This disk also has firmware updates.

PowerPrint Pro requires System 7.0 or later. If you require support for System 6.x.x, call the sales department at (800) 663-6222 to obtain PowerPrint/LT v2.5.

The DayStar MP Floppy provides the latest multiprocessing software for your Genesis MP or nPOWER upgrade card. Once you have installed Mac OS, run the DaySTar MP Installer to install the software listed below.

This Control Panel and Cache Control is for the following DayStar products:

Turbo 040, Turbo 040i, Image 040, Quad 040, Value 040, Value 040i and FastCache Quadra.

This drive/control panel is for Applied Engineering's Hard Disk for early Macintosh and Macintosh II machines. Please read the included Readme document completely so you fully understand the requireme