Wireless router problem - very limited range - HELP!

5 posts / 0 new
Last post
Offline
Last seen: 18 years 2 months ago
Joined: Jan 15 2006 - 21:48
Posts: 1
Wireless router problem - very limited range - HELP!

Greetings to all,

I need some help from you wireless experts out there! Just installed my first wireless router, a Netgear Rangemax WPN824. Unfortunately, the range "maxes out" at about ten feet! I am obviously doing something wrong, or I am missing some piece of equipment.

I'm running a 1.2ghz iBook with Airport, and my Internet isp is Direcway if that makes a difference. Any ideas as to why my range would be so terribly limited with this supposedly high powered router? I've already covered all the basic stuff like having it located away from interference, metaql, etc. It's on my wooden desk right above my computer, and if I walk 10 feet out of the room the connectin is gone. My son's Dell PC receives signal upstairs several rooms away, but the signal is weak there too.

Please give me some help... I can't stand the thought of talking to their technical support group again!

Vetlady

gobabushka's picture
Offline
Last seen: 1 month 9 hours ago
Joined: Apr 26 2004 - 16:30
Posts: 495
what do you have it near?

what do you have it near?

Diego_Knyte's picture
Offline
Last seen: 12 years 10 months ago
Joined: Dec 20 2003 - 10:38
Posts: 80
Channel problem?

I was talking with out DSL tech about 2 weeks ago. Not the main topic but I told him about low signal strength from our DSL modem (includes wireless). He said that most wireless routers will default to channel 9. For some reason, switching the config to channel 1 or 11 would increase the signal strength. I didn't catch, or it didn't come up, if it's just our brand or if it's with all routers.

Give it a shot, who knows.

-Dk

simon_C's picture
Offline
Last seen: 16 years 3 months ago
Joined: Dec 20 2003 - 10:38
Posts: 160
correction, they default to c

correction, they default to channel 6

there could be a load of different things. i suggest swapping the channel to 9.... or any other channel than 6 make sure the antennas are all connected correctly (even inside the router, take it apart iif you need to. my old rouer had a shoddy signal... turned out to be a disconnected internal antenna wire)

Whosawhatsis's picture
Offline
Last seen: 16 years 9 months ago
Joined: Aug 28 2005 - 01:49
Posts: 66
May be an obvious question, b

May be an obvious question, but have you tried turning on interference robustness? I was trying to use a linksys earlier today that would only give a very weak signal that never lasted long enough to connect from two meters away until I turned on interference robustness. Ideally, you don't want to have to use it all the time, but at the very least it can help you diagnose the problem.

Log in or register to post comments