Beige G3 PSU desktop to minitower

3 posts / 0 new
Last post
Offline
Last seen: 16 years 1 week ago
Joined: Dec 20 2003 - 10:38
Posts: 13
Beige G3 PSU desktop to minitower

Is it possible to put a desktop G3 beiges PSU into a minitower mobo. Will the PSU be able to connect to the mobo and will it power it?

g3head's picture
Offline
Last seen: 4 years 3 months ago
Joined: Dec 20 2003 - 10:38
Posts: 213
With a jumper setting

The connector is the same but the pins are slightly different. All you have to do tho' is change a jumper setting and it should be fine. IIRC the jumper is a block of 4 mins (2x2) and is behind the PCI slots and near the reset switch. The DT PSU needs the mac setting I think the tower and ATX PSUs use the other setting.

Offline
Last seen: 14 years 11 months ago
Joined: Feb 18 2004 - 02:09
Posts: 44
Yea... take a look at the boa

Yea... take a look at the board and you will see the jumper setting. I believe its even labeled properly. Quick jumper and it will power everything.

The B&W was simular but required more rewiring... the beige is pretty straight foward..

Shane

Log in or register to post comments