G4 into a G5 case conversion

3 posts / 0 new
Last post
Offline
Last seen: 18 years 2 weeks ago
Joined: Dec 20 2003 - 10:38
Posts: 279
G4 into a G5 case conversion

So, I got around to whipping up a little page for this. It isn't not 100% finished yet, but its fully functional and I am typing this from it right now. Enjoy.

http://www.mlode.com/~stuka/g45/

Offline
Last seen: 19 years 5 months ago
Joined: Oct 21 2004 - 09:46
Posts: 12
Looks good. How does the back

Looks good. How does the backplate look?

Offline
Last seen: 18 years 2 weeks ago
Joined: Dec 20 2003 - 10:38
Posts: 279
This is one of the unexpected

This is one of the unexpected downsides. The ports arent flush with the backpanel, no way to get around this. They are inside about 1/2". The bottom ports that areant used will be covered from the inside with plate aluminum. The upper part where the ports are has been trimmed with a dremel so its just a clean square hole. I had planned on making a backface that was going to be inset, but was unable to do to other reasons.

Log in or register to post comments