Issue with PowerMac G5 and DVD drive.

6 posts / 0 new
Last post
Offline
Last seen: 17 years 10 months ago
Joined: Dec 8 2005 - 13:18
Posts: 5
Issue with PowerMac G5 and DVD drive.

The problem: I ran software updater after doing a clean install of OS X due to a filestructure error.

Prior to the software update everything worked fine, but now it won't open or anything.

ASP recognizes it as "SONY DVD RW DW-U21A"

But when I run drutil in terminal, it says:

-chroco$ drutil tray open
-
- Could not find a valid device.
-
-chroco$ drutil status
-
- Could not find a valid device.

another issue is when I booted into single user mode, it would lock up before I could completely type in the "fsck -fy" command, yet it would still boot into OS X O.o

any of you out there in apple guru land have any ideas on what the issue could be? Or is the general consensus going to be to call apple?

Dr. Webster's picture
Offline
Last seen: 3 hours 22 min ago
Joined: Dec 19 2003 - 17:34
Posts: 1759
Can you boot from the drive?

Can you boot from the drive? If so, then there's a problem with your OS X installation, and your best bet would be to reinstall the OS. If not, take the machine in to be repaired.

Offline
Last seen: 17 years 10 months ago
Joined: Dec 8 2005 - 13:18
Posts: 5
Boot from the DVD drive? I

Boot from the DVD drive?

It won't open, and it won't even recognize it. No way to reinstall the OS if it won't open/recognize/read the drive...

-chroco$ drutil tray open
-
- Could not find a valid device.

should have opened it when F12 or the eject key on the kbd wouldn't open it.

moros's picture
Offline
Last seen: 12 years 9 months ago
Joined: Jan 21 2005 - 08:16
Posts: 65
start up holding the mouse bu

start up holding the mouse button down. IIRC this sends a message thro' hardware to open the DVD tray.

From there try booting off an OS X disk, if you have 10.4 you'll have access to the terminal to test whether or not you can then open it with software commands.

moros

Offline
Last seen: 17 years 10 months ago
Joined: Dec 8 2005 - 13:18
Posts: 5
Re: start up holding the mouse bu

start up holding the mouse button down. IIRC this sends a message thro' hardware to open the DVD tray.

That just wound up locking it up as well.

Guess I'll be calling tech support ASAP...

gobabushka's picture
Offline
Last seen: 7 months 3 weeks ago
Joined: Apr 26 2004 - 16:30
Posts: 495
try zapping the pram

did u try zapping the pram or resetting the open firmware (reset-nvram reset-all)?

Log in or register to post comments