Fun with FireWire/USB 2 card

16 posts / 0 new
Last post
Offline
Last seen: 12 years 4 months ago
Joined: Apr 22 2004 - 15:37
Posts: 378
Fun with FireWire/USB 2 card

I'm attempting to install a SYBA USB2/FW400 PCI card into by Blue/White G3. I have tested this card in the past with PCs and a Beige G3 and it worked great. Mac OS X recognized it on the Beige G3 and I could use either type of connector on it.

However it appears to knock the video for a loop on this newer G3. It sounds like it starts up normally, there's just no picture. The last time I tried this I left it unplugged overnight and it started again this evening.

Currently it has a 8.4GB IDE drive for booting and two 9.1 GB UW SCSI drives for misc storage for the moment. Other cards are the standard 16MB Rage128 video card and an ATTO SCSI card. The left and right PCI slots are free.

Any suggestions for placement of this card or hints for a replacement of said card?

themike's picture
Offline
Last seen: 12 years 4 months ago
Joined: Jul 21 2004 - 19:33
Posts: 455
Have you tried removing the o

Have you tried removing the original firewire module from the B&W? I hear those can cause all sorts of weird problems.

Offline
Last seen: 12 years 4 months ago
Joined: Apr 22 2004 - 15:37
Posts: 378
Not Yet

I haven't as of yet. I just did manage to get it to show video again. I'll wait a little while and try that.

coius's picture
Offline
Last seen: 10 years 2 weeks ago
Joined: Aug 25 2004 - 13:56
Posts: 1975
hmm..

did you try moving the card to another slot?

Offline
Last seen: 12 years 4 months ago
Joined: Apr 22 2004 - 15:37
Posts: 378
Yes

I tried both the left and right PCI slots. Same result on either one. I also tried connecting an external hard drive to the built-in FireWire connector. It didn't get far enough to boot.

Offline
Last seen: 12 years 4 months ago
Joined: Apr 22 2004 - 15:37
Posts: 378
Oh Well

I removed the SCSI card and the FireWire module and tried the USB/FireWire card in all three free slots. It still blanks out the video when it is turned on. Grrr...

At this point in time I'm thinking of an Agere-based FireWire card.

coius's picture
Offline
Last seen: 10 years 2 weeks ago
Joined: Aug 25 2004 - 13:56
Posts: 1975
is the machine overclocked?

and do you have the right config for the jumper settings?

your problem may be with the PCI Timing, and the fact that the bus is not playing happy with having cards that are not compatible with the timing. Also, is the video card in the 66Mhz slot?

Offline
Last seen: 12 years 4 months ago
Joined: Apr 22 2004 - 15:37
Posts: 378
Nope

I haven't even bothered trying to overclock this beastie. It's still running at its original 300mhz.

I do have a 333mhz chip from a Beige G3 I was planning on overclocking to 350mhz, but have not had the time to do so.

The video card is in the third PCI slot with the first being the leftmost one with the side opened.

protocol6v's picture
Offline
Last seen: 13 years 9 months ago
Joined: Apr 21 2006 - 20:58
Posts: 339
I had a 300MHz G3 and i overc

I had a 300MHz G3 and i overclocked it to 400 without any problems. Ran like a champ for over a year.

Jon
Jon's picture
Offline
Last seen: 12 years 10 months ago
Joined: Dec 20 2003 - 10:38
Posts: 2804
Re: Nope

The video card is in the third PCI slot with the first being the leftmost one with the side opened.

The 66MHz slot is the non-64-bit one. The one closest to the CPU is the 32-bit 66MHz slot. The other 3 are 64-bit 33MHz slots. See here.

Offline
Last seen: 12 years 4 months ago
Joined: Apr 22 2004 - 15:37
Posts: 378
Re: Nope

The video card is in the third PCI slot with the first being the leftmost one with the side opened.

The 66MHz slot is the non-64-bit one. The one closest to the CPU is the 32-bit 66MHz slot. The other 3 are 64-bit 33MHz slots. See here.

Whoops!

Apparently Computer Geeks didn't check the card position either. That was how it came to me. That might explain some of the slowness in comparison to other B/W G3s that I have tried. That also may explain the issue with putting the combo card in the right-most slot.
I'll put the video card in the correct slot and try again.

Thanks for your help!

EDIT: I placed the video card in the 66mhz slot. It powers up and boots, but no video appears. I hope the slot isn't bad.

Offline
Last seen: 12 years 4 months ago
Joined: Apr 22 2004 - 15:37
Posts: 378
Here's hoping....

I just won an auction for a Rev 2 motherboard with 400mhz G3 processor and Rage128 video card. I'll swap them out when it arrives and hopefully that will take care of it.

A lot cheaper than a G4 I was contemplating.... Smile

Jon
Jon's picture
Offline
Last seen: 12 years 10 months ago
Joined: Dec 20 2003 - 10:38
Posts: 2804
That may be why it got put in

That may be why it got put in the 64-bit slot. Huh. I do hope the new board solves it.

I'd also guess that CG didn't even know what slot it was supposed to go in, or that it even had a dedicated one.

Offline
Last seen: 12 years 4 months ago
Joined: Apr 22 2004 - 15:37
Posts: 378
Perhaps

I hope so too. I really like it and at times it seems faster than my Athlon 64 3700+ system.

I think that Computer Geeks primarily deals with PCs, although they do have a nice selection of used Macs too. At the time I bought this one I was wanting the least expensive Mac that could run Panther. Computer Geeks had it for $60 at the time which was the best price I could find around here.

Even if it turns out to be a Rev 1 board - it appears to be a Rev 2 due to the heatsink - it will have a better processor and video card. The video appeared to have some sort of daughter card on it.

Offline
Last seen: 3 months 1 week ago
Joined: Jan 19 2005 - 23:30
Posts: 700
you didnt happen to get a Bei

you didnt happen to get a Beige G3 mobo did you? because thats the only thing i can think of that would have a daughter card off the main video/audio card.....

Offline
Last seen: 12 years 4 months ago
Joined: Apr 22 2004 - 15:37
Posts: 378
Nope

According to what I've read, it's the DVD MPEG option that deals with DVD decoding under older versions of MacOS. I also have a Beige G3 with the A/V personality card so I do have something to compare against.

There's 4 memory slots like my current B/W G3 has. The last picture on the link below shows the heatsink. The picture of the video card also appears to match the image in the auction.

http://xlr8yourmac.com/G3-ZONE/yosemite/newfeatures.html

As far as I know, it's a Rev 2.

Log in or register to post comments