Anyone know the part number for the Edge Connectors (slots) for an Apple II?

6 posts / 0 new
Last post
Offline
Last seen: 1 week 2 days ago
Joined: Jul 14 2018 - 12:54
Posts: 146
Anyone know the part number for the Edge Connectors (slots) for an Apple II?

The title pretty much sums it up.  I have an Apple ][ plus board with a damaged connector at Slot 6 (pretty important slot), and I'm looking for a replacement cheaper than what I'm seeing on eBay.

Online
Last seen: 57 min 42 sec ago
Joined: Feb 27 2021 - 18:59
Posts: 472
green?

The originals may have been made by EDAC, but there are parts from many vendors which will fit. Are they green or black, and do they have the extensions with screw mounting holes ("lugs")?

You can use the EDAC 345-050-520-202 which is green and does have lugs, although I have never seen an Apple where they were actually screwed down. Sullins ECC25DRXH, or Cinch 50-25SN-11 are equivalent.

Offline
Last seen: 1 week 2 days ago
Joined: Jul 14 2018 - 12:54
Posts: 146
Black

Thanks for this, but I don't think these are the right ones.  The board I have is a ][ Plus, so the connectors are black with no mounting holes.  Sorry, probably should have specified that in the title as well as the post.  Honestly, I wish I had the Revision 0, but I'm not that lucky/rich.  However, if I ever get a replica board at least now I'll know what to get for it.  

 

In any case, aside from the right part numbers, I should also ask what would be a good source for them?  I've looked up the parts you suggested, and so far, they've either been out of stock, or the sight won't give the inventory?

Offline
Last seen: 4 hours 46 min ago
Joined: Jun 25 2020 - 17:00
Posts: 219
I got mine here
DistantStar001 wrote:

Thanks for this, but I don't think these are the right ones.  The board I have is a ][ Plus, so the connectors are black with no mounting holes.  Sorry, probably should have specified that in the title as well as the post.  Honestly, I wish I had the Revision 0, but I'm not that lucky/rich.  However, if I ever get a replica board at least now I'll know what to get&

 

https://www.mouser.com/

 

Part # A8D25DS27C2

 

 

Online
Last seen: 57 min 42 sec ago
Joined: Feb 27 2021 - 18:59
Posts: 472
black?

Black without lugs could be EDAC 395-050-520-201, Sullins [any letter][B or C]C25DRXN, Cinch 50-25SN-12, etc.

The key is that the pin pitch should be 0.100", 2 rows, 25 pins per row, 50 pins total, with 0.200" between rows. You can plug these into a parametric search engine like Octopart to see matches.

Offline
Last seen: 1 week 2 days ago
Joined: Jul 14 2018 - 12:54
Posts: 146
Found them!

Thanks!  I found them on DigiKey!  

Log in or register to post comments