ADT question about using audio vs serial

4 posts / 0 new
Last post
Offline
Last seen: 1 week 6 days ago
Joined: Oct 9 2011 - 12:54
ADT question about using audio vs serial

Besides bootstrapping which you sometimes can't avoid,

How bad is ADT (not pro client, but for DOS 3.3) when sending disk images over the audio ports vs using a Super Serial card?

It's a heck of a lot easier and cheaper to run audio cable between my Apple II area and my Mac which sits on my desk then it is to run 25ft of serial cable.

Since most of the time I'll be using the CFFA3000 card, this would only be for occasional use to transfer images to be copied onto real floppies since I haven't found a copy program yet that will bit copy between controllers in the Apple II (CFFA to Disk II)

Thanks,
Corey

Offline
Last seen: 2 years 8 months ago
Joined: Apr 10 2006 - 20:01
Re: ADT question about using audio vs serial

Corey986 wrote:
How bad is ADT (not pro client, but for DOS 3.3) when sending disk images over the audio ports vs using a Super Serial card?

The DOS 3.3 client isn't capable of using the audio stream.

Offline
Last seen: 1 week 6 days ago
Joined: Oct 9 2011 - 12:54
Re: ADT question about using audio vs serial

What versions of proDos are supported then. I can't run anything that requires more than 64k and a 65c02.

Thanks,
Corey

MarkO's picture
Offline
Last seen: 3 weeks 4 days ago
Joined: Dec 10 2011 - 16:26
Re: ADT question about using audio vs serial

IIRC, the current ADTPro Disk comes with v1.9.. It will work fine on a Non-Enhanced ][e..

Log in or register to post comments