IO error on Apple //e

6 posts / 0 new
Last post
Offline
Last seen: 1 year 3 weeks ago
Joined: Sep 19 2023 - 14:05
Posts: 3
IO error on Apple //e

I am occasionally getting an IO ERROR when executing commands, even when I successfully executed other commands before it gave me the error. If I check the kernel using CLOSED APPLE+CONTROL+RESET, it gives me the error message "IOU FLAG E5:1". If I check the kernel using the same method before the IO ERROR message appears in the console, the diagnostics tool tells me KERNEL OK. 

To add to the confusion, after I run into the IOU FLAG error, if I reset the computer using OPEN APPLE+CONTROL+RESET, the drive cannot recognize the disk, spinning endlessly. In order to fix it, I have to take the disk out (after stopping the drive) and manually rotate the disk so that the index hole is visible. This manual fix also allows me to use commands after the IO ERROR message is shown (if I try without the fix it displays the error again. I have found this out from trial-and-error)

To make my and your brain hurt further though, the drive is very random. It can go for a long time without me needing to manual fix it, but all of a sudden it wants to be handheld by rotating the disk as stated in the paragraph above. I could not make a pattern out of this no matter how long I stared at the screen. 

All of the above makes me think it is a drive issue (I have two Disk II's). If so, can anyone tell me what's wrong and tell me how to fix this or point me to resources that show me how to correctly fix this? I am a relatively new to vintage computing and have done maintenance on the Mac 128k internal floppy drive. 

Offline
Last seen: 28 min 16 sec ago
Joined: Jul 5 2018 - 09:44
Posts: 2587
Is your IOU socketed?  If so

Is your IOU socketed?  If so make sure it is seated properly.  Not a bad idea to check all the socketed chips.  Make sure you are grounded first of course.  Check for any signs of corrosion, etc.

 

Offline
Last seen: 2 hours 43 min ago
Joined: Feb 27 2021 - 18:59
Posts: 581
Odd

The business with the index hole is very odd, because the Disk II has no index sensor and there is no index signal to the interface card. So manually rotating the floppy disk is not doing anything.

The error "IOU FLAG E5:1" is a failure of the soft-switch test (see "Understanding the Apple IIe"). E5 is just the chip designation for the IOU chip, and 1 refers to the failed test. It means that the MIXED soft-switch was incorrect when its initial state was tested. MIXED is one of the latches that is not automatically reset, but is only initialized on power-up.

What could be happening is that after a crash (from what it is not apparent), the state of the MIXED soft-switch is different from what the diagnostics expect on power-up, so the test fails. This doesn't tell you anything about the cause of the problem.

S.Elliott's picture
Offline
Last seen: 4 hours 34 min ago
Joined: Jun 23 2022 - 16:26
Posts: 224
Watch out for rotting diskette jackets and clogged heads

These might or might not be relevant to your symptoms, but beware that a rotting diskette or rotting disk-jacket can cause symptoms like those:

  • A rotting disk-jacket adds friction, preventing the disk from spinning consistently.  The spindle motor might produce a groaining noise while trying to start the disk, or draw so much current that the power supply cuts out and causes a cold restart  A disk may stop in a location where there's so much drag that it won't start spinning unless you take the disk out of the drive and manually turn it to another position.  (This might be one of your issues.)
  • All that extra friction rubs the oxide coating loose from the disk, clogging the drive heads.  A disk that reaches this condition will clog the heads so badly that it won't be able to read, write, nor erase disks until the head is thoroughly wet-cleaned with alcohol.  (A cleaning diskette won't be sufficient.)
  • In the early stages of rot you may see discoloration around the hub ring, where it begins to tear away from the surface of the diskette.  Severe rot will cause the hub ring to fall off entirely.  (Inspect the hub ring for stains, discoloration.)
  • Some brands especially notorious for rot: Wabash, Bonus, and Photo Drive Up.

 

Here are some photos showing various effects of rot on a batch of Photo Drive Up diskettes.

 

Sorry for the mediocre quality of the photos, but I'm away from home right now so I don't have access to my camera -- these are just a handful of pictures that I happened to have loaded in a photo organizer on my laptop.  (If anyone has good pictures of diskette rot or clogged heads, please share!)

Offline
Last seen: 1 year 3 weeks ago
Joined: Sep 19 2023 - 14:05
Posts: 3
The IOU is socketed correctly

The IOU is socketed correctly and there are no signs of corrosion anywhere on the boards, chips, or cards.

Offline
Last seen: 1 year 3 weeks ago
Joined: Sep 19 2023 - 14:05
Posts: 3
Good to note. Thanks.I guess

Good to note. Thanks.

I guess the manual rotation could've been dumb luck, or a result of corrosion as the comment below you states.

Log in or register to post comments