I’m getting back into the apple II game after 30 years away from it. I purchased a clone and a real apple about a year ago. The clone works fine. The real apple has an issue in text mode on a colour monitor (Commodore). In HGR mode, the text is crisp with the normal colour fringing, but in text mode, the colour is so overdriven that you can’t read the text. I disconnected the 4.7K resistor to Q6 (colour killer transistor) and the text is the same in text mode or HGR (which it should be). I jumped the hue adjust control (which should ground the colour burst signal) and the colour is overdriven the same as in text mode which makes me think that the colour killer circuit is fine. Any ideas why grounding the colour burst would overdrive the colour on the screen?
Edit, I disconnected the 2.7K resistor that feeds the colour burst to the video out transistor and still the colours are completely overdriven.
I've attached 3 scope pictures. The 2 with the shorter fatter pulse are from the clone (one in text and one in hgr mode where you can see the colourburst). The one with the skinnier taller pulse is from the real apple with the resistor removed that feeds the colourburst to the video transistor.
Thanks
John
Maybe pictures of the monitor would be more helpful. Have you tried adjusting the video LEVEL pot?
Is this on a PAL system with the colour card, or an NTSC system?
The video signal width is the first thing to check, as are the resistor values. (Test to see if the resistors are operating in spec.)
Yes I have. If you turn it down just to the point, it loses sync, the colour will dissapear.
tn_20210111_104535.jpg
tn_20210111_104659.jpg
tn_20210111_104816.jpg
This is an NTSC system. How do you check the video signal width? I have a basic background in electronics, but video is greek to me.
The 3 resistors that feed the video transistor (R6,7,8 on my schematic) as well as R27 that feeds the colour killer transistor check fine.
I've come up with a workaround. The clone I bought came with an 80 column card which has auto switchover. This gives me 2 composite outputs. The commodore monitor has a rear input with separate luma/chroma. I put one output to the luma input, and one output to the front composite input on the monitor. With the selector switch on the monitor, I can pick either text or graphics.
I was just going to use the clone, but it has a hires graphics problem which I will start a new topic on.
Thanks
John