AGP cards in older AMD PC

10 posts / 0 new
Last post
dankephoto's picture
Offline
Last seen: 9 months 1 week ago
Joined: Dec 20 2003 - 10:38
Posts: 1899
AGP cards in older AMD PC

I picked up an AMD-based PC with an 850MHz slot A Athlon. The only thing I'm not too crazy about is its ATI Rage LT Pro AGP card.

dan k

dankephoto's picture
Offline
Last seen: 9 months 1 week ago
Joined: Dec 20 2003 - 10:38
Posts: 1899
details and the question

OK, soooooo . . . I'm a PC noobie . . .
I picked up an AMD-based PC with an 850MHz slot A(?) Athlon. The only thing I'm not too crazy about is its ATI Rage LT Pro AGP card. I think the AGP slot is 1x-2x, though the manual's specs don't say . . .

Shuttle AI61
AMD K7 processor based AGPset Mainboard
* CPU Support - AMD K7 processor 500 ~ 750+MHz
* Chipset - Features AMD-751and AMD-756 AGPset with I/O subsystems.
* Jumperless CPU Configuration
* Auto-detect CPU voltage
* Soft-configure CPU Speed (The CPU operating speed is software
configurable in the Category of Frequency/Voltage Control of the BIOS
Setup utility.)
* Versatile Memory Support - Equipped with three DIMM banks of PC100 compliant SDRAM to
provide up to 768MB of system memory.
* AGP Slots - Supports Accelerated Graphics Port cards for high-performance, component
level interconnect directed at 3D graphical display applications.
* PCI Expansion Slots - Provides five 32-bit PCI slots.

Nowhere does it say anything about the AGP spec, so I'll take a wild guess and suggest it's AGPv1.0.

I've got several PC-ROMed AGP cards, including an R7K and an Nvidia GF4 Ti4200. Thing is, the PC dun't seem to want to work with either of those installed. The thing gives some beeps (? 1 long, then (?) 3 short?), then just sits there.

Anyone have an idea why? I thought graphics cards like the R7K and GF4Ti would support most any AGP slot. Googling was useless, there's so much noise gathered with any sort of relevant search.

TIA,

dan k

Offline
Last seen: 18 years 8 months ago
Joined: Dec 20 2003 - 10:38
Posts: 14
AGP cards are required to be

AGP cards are required to be backwards compatible as far as speeds. They will just throttle down. The problems come in when they are used with the wrong voltage. There are 3.3 , 1.5 , and 0.8 . This might be helpful.

http://www.neoseeker.com/Hardware/faqs/kb/10,63.html

Dr. Webster's picture
Offline
Last seen: 13 hours 37 min ago
Joined: Dec 19 2003 - 17:34
Posts: 1747
That board has 2x AGP. Her

That board has 2x AGP.

Here's some more specs on it:

http://www.mainboard.cz/mb/shuttle/AI61.htm

WARNING: the above link contains adult-themed advertisements which may or may not contain nudity.

dankephoto's picture
Offline
Last seen: 9 months 1 week ago
Joined: Dec 20 2003 - 10:38
Posts: 1899
OK, so it's got a 2x AGP slot,

so why doesn't the confounded thing start up with either of my two more modern AGP cards installed? (R7K and GF4 Ti4200) I still haven't tried the GF4 Ti4600 from my other PC in it, but I don't expect any better results.

And what do the startup tones tell me? I tried it again (R7K) and got a long tone followed by 2 very short tones.

As you can see, I really don't even know what questions to ask! Sigh . . .

dan k

Eudimorphodon's picture
Offline
Last seen: 3 months 3 weeks ago
Joined: Dec 21 2003 - 14:14
Posts: 1207
Re: OK, so it's got a 2x AGP slot,

And what do the startup tones tell me? I tried it again (R7K) and got a long tone followed by 2 very short tones.

The tones should be documented in the motherboard manual. If they're not, then, well, the manual sucks. Try searching for "BIOS error beep", for instance. You'll get things like this:

http://www.pcstats.com/articleview.cfm?articleID=1223

Another page on AGP compatability:

http://www.ertyu.org/~steven_nikkel/agpcompatibility.html

A motherboard that old probably only works with 3.3v compatible cards. Keying *should* prevent you from inserting an incompatible card, but I will say I have seen motherboards which lacked keying on the AGP slot. Assuming everything's properly keyed, then, well, there's no Good reason it shouldn't work. Try upgrading the system's BIOS if there's a newer one available.

Those really old AMD chipsets could be *really* flakey, incedentally. Good luck.

--Peace.

dankephoto's picture
Offline
Last seen: 9 months 1 week ago
Joined: Dec 20 2003 - 10:38
Posts: 1899
Re: OK, so it's got a 2x AGP slot,

The tones should be documented in the motherboard manual. If they're not, then, well, the manual sucks.

Heh, yeah, the manual does suck.

Thanks Eudi for the advice, and the links - at that first url it says 1 long, 2 short = video problem. Heh, uh, yeah.

This is what comes of buying crap about which I know little. I just wanted a cheap gaming PC for my nephews, not another source of persistant anal itching. Grrr.

Well, I'll see if the BIOS is older than the available update, and update it if it is, though I hold out little hope.

Assuming that's useless, anyone have any suggestions for a cheap LB/CPU combo to replace this POS? Preferably it'd use SDRAM (which I already have) and something 1GHz or faster would be nice (are those incompatible?) The box is otherwise well equipped.

sigh . . .

dan k

Eudimorphodon's picture
Offline
Last seen: 3 months 3 weeks ago
Joined: Dec 21 2003 - 14:14
Posts: 1207
Just to rule out the obvious:

Just to rule out the obvious:

I know this will sound dumb, but... make sure you're seating the new cards completely into the slot. I've had this problem with AGP more then once, where it feels like it's in there, but it actually needs one last *ooph*.

--Peace

Offline
Last seen: 15 years 9 months ago
Joined: Dec 18 2004 - 07:19
Posts: 13
Check your motherboard's manu

Check your motherboard's manual to see if you can set a jumper for "Voodoo" cards. Many motherboards of this era needed a higher voltage pumped to the AGP slot, as required by Voodoo 3 and above cards.

JB

The Czar's picture
Offline
Last seen: 13 years 2 weeks ago
Joined: Dec 20 2003 - 10:38
Posts: 287
Re: Just to rule out the obvious:

Just to rule out the obvious:

I know this will sound dumb, but... make sure you're seating the new cards completely into the slot. I've had this problem with AGP more then once, where it feels like it's in there, but it actually needs one last *ooph*.

--Peace

Take out the video card completely and start the machine. Compare the beeps you get with no video card installed vs. when the card is in the machine. That could rule out an ill-seated card.

This may be somewhat obvious, but is the BIOS set to look for an AGP card? I know in some BIOSes that there is a toggle to use AGP vs. PCI video. If it's set to auto, manually tell the BIOS to use the AGP slot. You'd be surprised what that little switch can fix.

So much for plug n' play, huh?

Cheers,

The Czar

Log in or register to post comments