Apple II

ROM 3 GS won't save Control panel settings, but keeps Time

Submitted by mkinn on August 30, 2021 - 11:29pm

New 3.6 VDC Lithium battery, + side towards the back of the machine, keeps time perfectly, but won't save Baud rate or Mouse tracking speed.

I'm pressing Return after changes to save them. Same for CDA's.  Nothing in the owner's manual about this.

Forums: 
Apple II

Apple A9M0107 5.25" Disk Repair

Submitted by jnoxon on August 30, 2021 - 11:12am

I received an A9M0107 5.25" (1986 Unidisk) floppy drive with a IIgs I bought recently. When attached to the computer, the LED flashes briefly a few times at power-up, but otherwise it shows no signs of life. There's no motor movement, and GS/OS doesn't show it in the Finder. I know the Smartport interface is fine, because I'm able to read/write disks using a different drive.

Forums: 
Apple II

Apple //e no power when Disk ][ drives are attached

Submitted by ryandesign on August 24, 2021 - 9:05pm

Hello friends! I figure it's about time I created an account on this site given how long I've used Apple computers. 

I just took my non-enhanced Apple //e out of storage yesterday and spent several hours using it successfully. Today it would not power on (no beep, no LEDs). I isolated the problem to the Disk ][ drives: when both are disconnected from the Disk ][ controller card, the computer starts normally. 

Forums: 
Apple II

Any interest in a new Apple /// memory board?

Submitted by brouhaha on August 24, 2021 - 5:55am

I have PCBs and connectors arriving tomorrow for a prototype of a new Apple /// memory board, using modern components (e.g., CMOS SRAM). The initial version is a 256 KiB board, as proof of concept. Is this something anyone might want?

 

Compared to the Apple "5V" memory board, this uses much less power, so it doesn't need the power resistor from +12V to +5V that was present on the Apple board, and it puts less load on the power supply and generates less heat.

 

Forums: 
Apple II

//e rom access speed

Submitted by bmb on August 21, 2021 - 9:07pm

Hello Everyone,

Forums: 
Apple II

CA3146E Chip - Disk II

Submitted by Heyme on August 21, 2021 - 3:07pm

Well i seem to of  found the issue with writing to disks with my DISK II drive.  The Transistor in the CA3146E chip that drives the Q2 right/Write  Transistor is shot.  all the others on the chip test ok, but pin 8 is dead..

Seems like this is now a discontinued part.  I have 3 Ebay  ones coming from China, with an ETA of Oct/Nov.  Anyone have a better source?  Digikey/newark/etc all fail to find it..  I am not interested in paying as much shipping as the cost of a DISK II drive to get it here (Canada)..

 

Thanks

 

 

Forums: 
Apple II

T3 Transformer Specifications in Astec Apple IIe Power Supply

Submitted by Kotomo on August 19, 2021 - 11:37am

I have had an Apple IIe for several years now that I power up and play around with from time to time, but not on a regular basis.  I went to power it on one day recently and found it be completely dead.  I decide to open it up and check for power coming out of the main harness from the power supply, but get nothing on either the 12v and 5v rails. 

 

Forums: 
Apple II

Disk ][ Front Panel

Submitted by PTB on August 18, 2021 - 10:33pm

Just wondering...

 

Does anyone know what manufacturing method was used for printing/painting/cutting the embossed aluminium overlay on the disk ][ drives ?

Does any such service still exist? And is affordable.

 

I know Maceffects are doing new labels for apple ]['s themselves but the disk ][ seems to have a different finish.

Cheers

Dave

Forums: 
Apple II

Apple ][ Fair Value

Submitted by moxzero on August 18, 2021 - 9:01am

I'm a new member looking into buying a A1S1 . Would like to know roughly what is a fair value for one in excellent condition? Thank you in advance.

Forums: 
Apple II

Pages

Subscribe to Apple II