I believe these are the correct make/model/vintage, if anyone is looking!
From the pics on eBay. They don't look like the correct caps.
I thought the correct ones where the Phillips 22uf 25v 4.5mm x 10.5mm axial.. do you have the correct make/model info? Thanks!
I don't recall the exact part number. It's not just size and manufacturer, but package and series you need. I think the last set I got was from a surplus place I went in person, but I had an original cap that was damaged from an Apple-1 with me to make sure it was the same.
There are modern ones that look pretty close and would be safer to use. I may have that part number also from an old mouser order. They aren't exact but they are close. I can look tomorrow.
Well, I made the mistake of purchasing this item thinking that they were correct for my Apple 1 replica. They were all bad, a few were open and the best were only about 10uf with very high ESR. They must be very old stock. Don't waste your money.
East Syracuse, NY
Here is a different set from Newton: http://www.ebay.com/itm/261723098836?_trksid=p2060778.m1438.l2650&ssPageName=STRK%3AMEBIDX%3AIT
Those are widely available - if you just want a part of the correct value, fit and the approximate color:
Vishay part number:MAL202138229E3
Hi dear friends, i find this:
Dimension and colour are best for good replica
Best regards from Italy
What are the correct dimensions for the original small blue 22uf caps?
I suppose someone might have the official Philips data sheet, but I measure them as approximately 11mm x 6mm
I thought the 4.5mm looked a bit small in dia, but pretty close on the width.