Apple II

Europlus white box before Reset

Submitted by pfaraday on April 3, 2016 - 7:18am

After switch on I get a white box over the whole screen and need to press reset

Forums: 
Apple II

Disk II Positioning Disk fault?

Submitted by pfaraday on April 3, 2016 - 7:10am

Disk II behaving odd, Positioning Disk spinning with out stopping!

Forums: 
Apple II

solved

Submitted by insanitor on April 2, 2016 - 2:30pm
Forums: 
Apple II

Bandinelli Software

Submitted by wishtoknow on April 1, 2016 - 10:46pm

According to the AE Phasor manual 1.1, there is
alisting for a game called Auto Gyro that uses
AE Phasor or I guess is Mockingboard compatible?

I have gone through asimov in the game section
to look for this particular game? Anybody herd of
it? Can supply screen shots etc.

Regards

Forums: 
Apple II

VisiCalc DOS3.3.Launcher

Submitted by 6502enhanced on April 1, 2016 - 3:21pm

I try to start VisiCalc from my CFFA with DOS3.3.Launcher (V 2.2) - the Launcher starts, but after a short moment the Apple IIe says:

]
90FB- A=00 x=07 Y=00 P=32 S=E9
*

With the "example" program that comes with the Launcher (Key Bored) it is no problem to start it from the CFFA.

I set the launch options using the DOS3.3.COPIER - tried both.

What could be the problem with VisiCalc?

Is VisiCalc using the auxiliary memory that the DOS3.3.Launcher needs by itself?
Or could the CFFA the problem?

Forums: 
Apple II

Can anyone identify this error or have a solution?

Submitted by VanguardFed on March 31, 2016 - 9:08pm

An Apple II Plus that I am looking at seems to not be booting properly. When booted up without software it does not produce the typical 'Apple ][' but a mass of j's, 5's and u's.

He said that it could be that he needs to reset the ROM.
Inside there is a GraphiCard printer card, a SuperSerial card, an Apple Disk control card, and an Applied Engineering Viewmaster-80.

Forums: 
Apple II

Can ADTPro use an "Apple II Serial Interface Card"

Submitted by pfaraday on March 30, 2016 - 12:27pm

Can ADTPro use an "Apple II Serial Interface Card"

Forums: 
Apple II

European source for europlus key switch and cap

Submitted by pfaraday on March 29, 2016 - 3:40am

source this side of the pond for keyboard switches

Forums: 
Apple II

Basement-find Apple ][ + problems

Submitted by garicao on March 28, 2016 - 7:09pm

Hi...i recently dug out an Apple ][ + from the basement. It includes a green monitor, dual disk drives, and printer. I’m hoping to find advice (for sure) and buy parts (if needed) from people who have one or both to spare.

Plugged it in and started right up...even ran for a half hour before the power supply fried in an exciting cloud of sparks, smoke, and stink. Through the wonders of the web, i learned about and replaced a bad capacitor and ps seems to be ok. Good reminder not to leave old electronics on and unattended.

Cards installed on mobo:

Forums: 
Apple II

DOS33Launch.shk and CiderPress

Submitted by 6502enhanced on March 28, 2016 - 11:03am

Hi,

I want to use DOS33Launch to put some programs on my CFFA. I loaded DOS3.3.Launch.shk from asimov to my PC. Then I extracted the file with CiderPress - but on that way I got no usable data (tried also to put these on CiderPress on a new created diskimage).

To send the .shk file with ADTPro to the Apple II and use there shrinkit was also not successful ...

What am I doing wrong? How can I make a normal diskimage from the .shk file from asimov using CiderPress on the PC?

Thanks.

Forums: 
Apple II

Pages

Subscribe to Apple II