Apple II

Just got an Apple IIe, boot issue

Submitted by Norion12 on September 23, 2019 - 12:56am

Heya guys, I got an Apple iie from an erecycling lot, I was able to get it to boot fine, but it was super dirty, so I cleaned the whole computer and reasembled it. 

After I got it back together, when I turn on the IIe, it flashes a full white square, then fades out everyother line to go away, then comes back to a full white square, does one low beep, then repeats this.

 

I ran the self diagnosis, (holding both apple keys and turning it on) and its says "Kernel Okay"

 

Forums: 
Apple II

[Solved] Apple //c diagnostic loops continuously

Submitted by william_tell on September 22, 2019 - 4:20pm

I have an Apple //c ROM3 (which I upgraded just for the diagnostic ability).

I started out with a bad RAM indicated in position low 7, replaced it, then next was position low 0, and then high 6.

After replacing high 6 RAM, now diagnostics runs continous loop with small color blocks showing, and then a brief flicker just when I am eagerly hoping for the message System OK.  But instead it seems to start over.

 

What is this telling me?

Forums: 
Apple II

Apple ][+ will not boot from known good card and drive

Submitted by william_tell on September 19, 2019 - 3:12pm

Hi all,

I have a good, working Apple ][+ that I have used to verify a disk ][ drive and controller.    I got an a new-to-me ][+ from my dad's attic.  It will boot to ] prompt with no cards inside.  When I instal the controller into slot 6, and single disk ][ drive, it attempts to boot on power-up, and does the seek to track 0 clackity-clack, but never boots a known good diskette.

Any ideas what on the main logic board I can look to repair/replace?

 

 

 

Forums: 
Apple II

Franklin Ace 500 errors

Submitted by KayAB on September 19, 2019 - 1:45pm

Hi!

 

I bought a Franklin Ace 500 on Craigslist, in box, with manual and power supply, but no disks. The composite out is very clear, showing "ACE 500 V1.0" and the copyright notices.

An Apple IIc buddy prepared some floppies for me. Some games, and a DOS 3.3 disk. inserting the DOS disk or most of the game disks and powering on results in:

ERR

0803=

%

None of the games work, some do nothing, with the drive just spinning and no prompt appearing,  one showed "Relocation/Configuration error" another shows:

ERR

07FB=

%

 

Forums: 
Apple II

Help with formatting and installing DOS 3.3 onto a floppy for a Apple IIe

Submitted by The Fruitarian on September 17, 2019 - 3:28pm

Greetings!

 

I just found an old Apple IIe and bought some floppies that are DS/DD and I am having some trouble formatting and installing certain games or programs onto a the floppy.

I did everything as instructed in this video: https://www.youtube.com/watch?v=_DRql_Z-d7k&t=105s

However once I put in the floppy, turn the Apple IIe on, type LOAD and play the audio it says loading INSTA-DISK but shortly after I get a CHKSUM ERROR.

 

Any help would be appriciated.

Forums: 
Apple II

May have an EDD+ and //gs 1Mb memory card to trade.

Submitted by Lee Adamson on September 16, 2019 - 9:21pm

Howdy folks.  I obtained my //gs motherboard and power supply today, both of which thankfully work.

 

It also came with a beat up case, a fully populated Apple 1Mb memory expansion card (which I don't need because I have a RAMGS/8 for it, and is probably worthless), and an Essential Data Duplicator Plus card, revision B.

 

Forums: 
Apple II

IIe female power connector part number?

Submitted by Lee Adamson on September 14, 2019 - 1:45pm

Does anyone know the part number (or generally what I need to look for at an electronics supply store) for the female (motherboard-side) power connector for the IIe?  I'm looking to get one to solder into a ROM1 IIgs board that I'm putting in a IIe case.

 

Thanks!  :D

Forums: 
Apple II

IIc with different command prompt?

Submitted by Statsman1 on September 12, 2019 - 10:41pm

Hey everyone!

 

I have 2 Apple IIc computers and they both seem to work just fine, but I have noticed one difference that I can't solve, and I can't seem to find an answer on the Internet.

One command prompt is a square close bracket:   ]

The other machine's command prompt is this F6 symbol:   §

 

One keyboard is the US version, and that one has the F6 prompt.  The other is a CAN version (with French characters on some of the keys), and that has the square bracket prompt.  Other than that, both machines seem identical.

 

Forums: 
Apple II

Two issues

Submitted by Punkyclown on September 10, 2019 - 12:12pm

Hi All, Just enjoying my new (to me) IIgs.  Two quick questions, first I am running my System 6.0.4 off of a 3.5 drive. So How come when I change the color of my trash can it does not stay changed when every other icon does?  Second, I used "Flashboot" for a while and it gave me much more functionality, but was wonky.  But it did allow me to add items to my Apple Menu no problem. But with the System disk when I stick an item in the Desk'aces, folder they do not show up.  What file do I need to add the the system to make them active?The Help is much appreciated!Brad Hansen

Forums: 
Apple II

Cross-compilation with CC65 for IIgs/65816?

Submitted by Lee Adamson on September 9, 2019 - 8:43pm

It looks like CC65's assembler supports the '816, but the C compiler does not?  Hmm.

 

Anyone ever mess with this?

 

Are there any other //gs cross compilers out there?  Doesn't look like WDCTools can target the IIgs.  Most of the '816 stuff I am finding is for the SNES.

 

I don't think I'm smart enough to patch cc65's compiler to emit proper '816 asm...

Forums: 
Apple II

Pages

Subscribe to Apple II