Apple II

MVP Forth / RSL Forth (Floating Point Math) - Diskimages

Submitted by tokabln on March 21, 2019 - 2:46pm

Folks, the title tells you what I'm looking for.

 

If there is anyone who can deliver a MVP Forth (Floating Point Math) version or the similar RSL (Redshift Limited) version as diskimage(s) that would be great.

I'd like to use this peice of software with the cloned CCS 7711 Arithmetic Processor Card.

Forums: 
Apple II

Apple Iie diagnostic grab screen

Submitted by Zurück on March 21, 2019 - 2:32am

Hello,

i have an apple IIe, first step was to repair the power supply, changing the AC input capacitor.

Now I want to enter the diagnostic screen and I get only garbage. Entering basic display although some garbage screens.

I have attached two screens.

 

How to start the error search?

 

I have:

Multimeter

Oscilloscope

Weldering tool

 

Thanks for the support.

 

 

 

 

Forums: 
Apple II

So there are currently no CF controller cards in production?

Submitted by Willz06jw on March 20, 2019 - 10:08am

Hi guys and gals,

 

I just bought an Apple IIGS, keyboard, mouse, and monitor...but I am supprised to find no CF or SD controller cards currently available.  CFFA3000, for instance, is unavailable.

 

Does anyone know a good controller card in production/where I could find one not in production?  I don't want to do the SCSI to external hard solution if humanly possible.

 

Thanks for your help,

Will

Forums: 
Apple II

Macintish 12" RGB monitor ans APPLE II?

Submitted by robbo007 on March 20, 2019 - 6:20am

Hi all,

I managed to salvage fromt he tip a Macintosh 12" RGB monitor. Is there any way I can use this with my Apple IIe? Can I get a RGB card for the Apple IIe and maybe a dongle? 

 

Cheers,

Rob

Forums: 
Apple II

Apple II Disk interface

Submitted by Gary C on March 18, 2019 - 5:15pm

Hi

 

Been working on my Apple II europlus for a few months now and have fixed the blown PSU, replaced the fried CPU in the motherboard, repaired the broken keyboard and now it powers up to the [ prompt in basic and seems to run ok.

 

However, how does the disk II interface and drive normally operate ?

 

If I install the card (in slot #6) and connect up the disk drive, the computer hangs with Apple ][ but no [ prompt and the drive continually spins ?

Forums: 
Apple II

Need help sourcing correct paint for Apple IIe base plate

Submitted by Verault on March 18, 2019 - 9:32am

I recently saved/bought a pallet of Apple II computers that were from a school put into storage decaded ago and forgotten. Apparently the roof caved in and these apples have seen better days. Due to my compulsion im determined to restore as many as I can (albeit slowly). I picked a particularly bad one out of the pile to determine what I am dealing with.

 

Forums: 
Apple II

Apple IIc problem

Submitted by clockchip on March 17, 2019 - 5:37pm

Hello,

 

maybe someone can help me to identify the problem of my Apple IIc.

 

When I start the computer he try to access the Floppy but he will not boot from it => Message "check disk"

Also random characters are appearing on the screen.

Sometimes after start it shows a prompt, and many random charaters appearing on the screen.

I attached also some screenshots to this message to show you the problem in a more visual way.

 

best regards

Clockchip

 

 

Forums: 
Apple II

"Digital Electronic Systems" Hard_Drive questions

Submitted by jlafleur on March 16, 2019 - 1:51pm

I very recently procured two of these devices, both with interface card (however one missing its ribbon cable)

I haven't tested them with my Apple ][+ yet but I figured I would ask here if anyone had some suggestions.

They appear to have been serviced sometime in the early 1990s.

The web didn't pull up much beyond press releases from 1983...

The model of these is "WAP10" which suggests a 10mb rather than the 5mb drive listed in the release.

Forums: 
Apple II

apple IIe stuck

Submitted by zappx on March 15, 2019 - 7:27am

Hi guys, on power on my Apple IIe PAL filled the video with garbage, i replaced all the RAM IC and it started. I was able to interact. I wrote something and press return and i got "?SYNTAX ERROR".After some power off and power on, i got  screen but i'm not able to interact, if a press CTRL+closed apple+reset the diagnostic start and I got KERNEL OK.Any suggest to fix the problem?thanks a lot

Forums: 
Apple II

Pages

Subscribe to Apple II