Apple II

Can ADTPro use an "Apple II Serial Interface Card"

Submitted by pfaraday on March 30, 2016 - 12:27pm

Can ADTPro use an "Apple II Serial Interface Card"

Forums: 
Apple II

European source for europlus key switch and cap

Submitted by pfaraday on March 29, 2016 - 3:40am

source this side of the pond for keyboard switches

Forums: 
Apple II

Basement-find Apple ][ + problems

Submitted by garicao on March 28, 2016 - 7:09pm

Hi...i recently dug out an Apple ][ + from the basement. It includes a green monitor, dual disk drives, and printer. I’m hoping to find advice (for sure) and buy parts (if needed) from people who have one or both to spare.

Plugged it in and started right up...even ran for a half hour before the power supply fried in an exciting cloud of sparks, smoke, and stink. Through the wonders of the web, i learned about and replaced a bad capacitor and ps seems to be ok. Good reminder not to leave old electronics on and unattended.

Cards installed on mobo:

Forums: 
Apple II

DOS33Launch.shk and CiderPress

Submitted by 6502enhanced on March 28, 2016 - 11:03am

Hi,

I want to use DOS33Launch to put some programs on my CFFA. I loaded DOS3.3.Launch.shk from asimov to my PC. Then I extracted the file with CiderPress - but on that way I got no usable data (tried also to put these on CiderPress on a new created diskimage).

To send the .shk file with ADTPro to the Apple II and use there shrinkit was also not successful ...

What am I doing wrong? How can I make a normal diskimage from the .shk file from asimov using CiderPress on the PC?

Thanks.

Forums: 
Apple II

REQ: Apple II 3.5 installer disk driver "Appledisk 3.5"

Submitted by insanitor on March 27, 2016 - 10:37am

Guys.

I am looking for an image of this disk.

It comes with the Apple II 3.5 Superdrive disk controller card.

It is mentioned in the manual on page 3.

I have been looking for it on Asimov and other sites but I cannot find it.

Can anyone help me out?

Forums: 
Apple II

Apple //c won't boot when serial connected?!?!

Submitted by BadDadBad on March 26, 2016 - 5:56pm

Hi all,

Just acquired a NTSC //c ROM0 , and have an odd problem with the serial port (modem). If the //c is connected to my PC with null modem cable, and PC is powered on, the //c won't power on, nothing, no LEDs, remove the serial cable and it comes to life, reconnect the cable and I can send serial data to the //c from the PC, ADTPro won't receive a file list from the PC, I have a suspicion the //c won't send data to the PC.

Forums: 
Apple II

An introduction and a question

Submitted by VanguardFed on March 25, 2016 - 6:46pm

Greetings!

First off, I would like to apologize if this is not the place for these type of introductions or questions.

Forums: 
Apple II

Apple II europlus Dealer disk

Submitted by pfaraday on March 25, 2016 - 6:46pm

plus Dealer Disk same as euroPlus Dealer disk?

Forums: 
Apple II

Is this possible?

Submitted by wishtoknow on March 24, 2016 - 12:30am

While searching ebay for books, I came across
a book for the Apple ][ that I have not heard of
before. The title is

The do's and don'ts of DOS by Brian Howard (First Edition 1979)

Can anyone confirm this book is valid? (Photos would be nice)
I have tried google but have turned up 0 results.

Regards

Forums: 
Apple II

ADT Pro and VisiCalc

Submitted by 6502enhanced on March 22, 2016 - 2:03pm

Hi,

I want to use some calculations that I have made with VisiCalc on a real Apple II+ with the Emulator AppleWin.

Forums: 
Apple II

Pages

Subscribe to Apple II