Apple II

Help_The Best Way to Copy Files to the CFFA Card?

Submitted by gsmcten on July 13, 2013 - 7:51pm

All,

I need help.

I have been away from doing regular Apple II stuff for a while.
I want to get back to it, but it seems somewhere along the path
(no pun intended)I have lost my way.

I am back at my trusty Platinum IIe trying to copy all of
my disks (Games and Utilites) to my CFFA Cards.
I have read the CFFA Manuals, but there does not seem to be a definite step-by-step
procedure for copying programs.

For instance:

Forums: 
Apple II

Apple IIe memory removal and replacement

Submitted by Geoff1985 on July 13, 2013 - 11:25am

My Apple IIe gives me the following after the RAM test RAM: 0 1 0 0 0 0 0 0

I am assuming that it is stating that the chip at F6 is bad. Can I unsolder and replace? Is there any special trick to doing this to avoid damaging the other components or the replacement? As far as a replacement chip goes, am I limited to what I can scavenge from another motherboard or is there a source for getting new chips? Any and all advice is most appreciated. Thanks!

Forums: 
Apple II

A couple of SuperSerialCard questions (simple stuff for sure)

Submitted by Keatah on July 11, 2013 - 8:54pm

I'm doing some basic experiments and learning the ins and outs of the SSC. Finally!! Currently I have a basic setup II+ to PC (SSC-cable-DB9serialport).

Is it normal for the terminal (PC hypertem) to have to be set to VT100 and FORCE INCOMING TO 7-bit ASCII? FOr unless I do that I get some extra garbage on the PC side.

The 8-bit / 7-bit dip switch on the card doesn't seem to correct this.

Now, if I use VT102 emulation on AlphaCom, I don't have this problem.

What's going on here.

Forums: 
Apple II

Trouble with ADTPro sending garbled text to Apple IIe

Submitted by Revontuli on July 9, 2013 - 10:52pm

ADTPro is sending garbled text when I try to send data to boot my Apple IIe, but it's consistent garbled text. Any suggestions?

Forums: 
Apple II

Spartan Apple II Emulator for C64 on ebay now.

Submitted by gsmcten on July 8, 2013 - 8:35pm

Good evening All,

Imagine my surprize this evening when I went up to eBay and seen this:

http://www.ebay.com/itm/141012520377?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649#ht_178wt_909

This is another of the "Holy Grail" finds.
Spartan did not make that meny of these things.
It's kinda like the C64 version of the MEC AND it uses Apple II cards, disk drives, and software.

Forums: 
Apple II

Can Apple II joysticks work on a GS ?

Submitted by mjnurney on July 7, 2013 - 12:38pm

So after all that , does the Apple ii joystick work on the Apple GS ?

Forums: 
Apple II

Applied Engineering: The Conserver for GS

Submitted by Jim_GS on July 7, 2013 - 10:58am

I recently experienced a power surge that blew the fuse for my AE GS Conserver. I removed the fuse and found that it had absolutely no ID markings on it at all....never saw a fuse without some ID before? Does anyone know the correct fuse to use with the Conserver?

Thanks
Jim

Forums: 
Apple II

Need this screw

Submitted by tkh on July 4, 2013 - 3:01am

I have a simple question.
I recently have purchased some components for my A2e.
The problem is I don't have the right nut and bolt to attach these to the back.

With this post, I have attached a picture of the screw that I need along with a quarter for size comparison.
Please help me identify this with name and place where I can possibly get them.

Thank you

Forums: 
Apple II

Apple IIe SCSI card device support

Submitted by tkh on July 3, 2013 - 1:17am

Hi, I have an Apple IIe (first release). Recently, I got a SCSI card (NOT hi-speed) and trying to make use of it.

Forums: 
Apple II

convert Apple IIe or IIc keyboard to USB

Submitted by option8 on July 1, 2013 - 11:37pm

Now available: RetroConnector keyboard shield for Apple //c and //e.

Turn the built-in keyboard of your classic Apple II into a USB keyboard.

Forums: 
Apple II

Pages

Subscribe to Apple II